Search:

Type: Posts; User: Trust

Page 1 of 17 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    810

    Hmm check your coilover mounting. Look inside and...

    Hmm check your coilover mounting. Look inside and see the bearing is it smashed? That will explain the sound usually.
  2. Thread: CAI Intake

    by Trust
    Replies
    6
    Views
    1,371

    Anyway, Stock airbox is good. If you need to...

    Anyway, Stock airbox is good. If you need to increase air intake, go for bigger TB and intake manifold as a set.

    Lol Fahrz I am amaze no matter how time past you are still very consistent in your...
  3. Replies
    183
    Views
    35,847

    Hmm you might want to consider dropping in the...

    Hmm you might want to consider dropping in the camshaft before you tune or else wasted....
    Camshaft canlook for one about 272 degree and higher lift... our stock retainers and springs can tahan...
    ...
  4. Thread: Anti roll bar

    by Trust
    Replies
    3
    Views
    737

    Summit 22mm good about 270.

    Summit 22mm good about 270.
  5. Replies
    4
    Views
    884

    Deep maybe can try these.... Tomei Yap...

    Deep maybe can try these....

    Tomei Yap Brothers about 1000 - 1100

    Racetech:
    BC V1 1000 - 1100
    BC BR 1200 - 1400.

    There is also Tein and Tanabe maybe you wanna take a look, all depends on...
  6. Replies
    11
    Views
    3,053

    Front bumper about 400-600 Side skirt about...

    Front bumper about 400-600
    Side skirt about 200-300
    Rear Bumper about 400-500
    Lip about 200+

    Total about 1k+ If you save and use stock bodykit...
    Can do other things....
  7. Replies
    12
    Views
    6,333

    Its kinda true but not really, Stock GB about...

    Its kinda true but not really,

    Stock GB about 3K rpm Speed 100
    Mivec GB about 3.2k Rpm Speed 100..

    So considering you might up shift faster to fifth gear maybe +/- the fuel so so... not much...
  8. Replies
    2
    Views
    743

    Usually around 60- 80 dollars... Actually if hard...

    Usually around 60- 80 dollars... Actually if hard to depress usually your throttle body engagement mechanism there got carbon... spray a bit of oil those remove carbon spray can liao. Just follow...
  9. Replies
    183
    Views
    35,847

    hahq kangwei just save for your child and maybe...

    hahq kangwei just save for your child and maybe next car lo haha. i think you could feel better. lol.
  10. Replies
    183
    Views
    35,847

    lol kangwei i guessed we are in the same boat....

    lol kangwei i guessed we are in the same boat. ive stop indulging myself in modding lancer ever since ive seen the dyno numbers on my ride ha. still love to drive it maintain it thats all till a next...
  11. Replies
    183
    Views
    35,847

    1. Change parts or mods 2. Tune 3. RUn Dyno....

    1. Change parts or mods
    2. Tune
    3. RUn Dyno.
    4. You will want to change car.
  12. Replies
    17
    Views
    1,696

    haha anyway fellow bros thanks a lot for the...

    haha anyway fellow bros thanks a lot for the replies
    did made me feel better. but im happy with what it is now. My focus now is working towards a better ride.
    Thanks to alot of bros and...
  13. Replies
    17
    Views
    1,696

    Yes trent i do understand just didnt expect it to...

    Yes trent i do understand just didnt expect it to be less than 3 figure haha.
  14. Replies
    17
    Views
    1,696

    haha. hey bros yes of course i learn a lot but...

    haha. hey bros yes of course i learn a lot but well... ran dyno on uber and its only 99 hp.. sadly
  15. Replies
    17
    Views
    1,696

    Mod and mod, have you dyno?

    Today did a dyno tune and run to realise how pathetic is lancers horse power after all that i had put in.
    I was suddenly being reminded by Fahrz post the other time when there was an arguments about...
  16. Replies
    4
    Views
    836

    Yes fahrz thanks alot!

    Yes fahrz thanks alot!
  17. Replies
    4
    Views
    836

    Garg hmm i heard some metallic sound could be......

    Garg hmm i heard some metallic sound could be... ok thanks!
  18. Replies
    4
    Views
    836

    BC V1 Coilover Dipping.

    I need Advice on Coilover issue.

    My Suspension BC Coilover V1 is dipping at the left rear of my wheel. Meaning to say the rear height is uneven between the left and the right. Is there any issues...
  19. Replies
    25
    Views
    3,237

    bearing about $50... take out gearbox that is the...

    bearing about $50... take out gearbox that is the expensive part... about 280 - 350...

    Do this if you are planning to replace your clutch.
  20. Replies
    7
    Views
    1,964

    Thunder Do begin with an end in mind. Then...

    Thunder

    Do begin with an end in mind. Then start and map out plan towards it and then tune to end and enjoy.

    Before you go and tune... i suggest you mod finish 1st... you don't want tune $300...
  21. Replies
    11
    Views
    5,120

    haha ash lol dont tell u hahaahh

    haha ash lol dont tell u hahaahh
  22. Replies
    11
    Views
    5,120

    Anyway, whoever is going to buy the camshaft,...

    Anyway, whoever is going to buy the camshaft, hmm... make sure you read up and know how to measure so you won't get con between the different degree of camshaft.... unless whoever you buy from or...
  23. Replies
    11
    Views
    5,120

    Aceh, nope i didn't nothing fly out of my engine...

    Aceh, nope i didn't nothing fly out of my engine YET hahaha.
  24. Replies
    10
    Views
    1,661

    Haha agreed. Cheers!

    Haha agreed. Cheers!
  25. Replies
    11
    Views
    5,120

    its good. gave me a good overall powerband and a...

    its good. gave me a good overall powerband and a little machiam vtec kick at 4k rpm. also do get someone skilled to do it for you.
  26. Replies
    10
    Views
    1,661

    aha fahrz.i.totally remembered you saying all...

    aha fahrz.i.totally remembered you saying all that some time long ago surprisr to see it all again.
  27. Thread: Arb

    by Trust
    Replies
    17
    Views
    2,211

    thicker better imo. 22 is good get a summit and...

    thicker better imo. 22 is good get a summit and change the bushing.
  28. Replies
    7
    Views
    1,473

    like what bro garg mentioned short for high end...

    like what bro garg mentioned short for high end long for drivability.

    If you often high rev want to stay in high rpm for power go short.

    Long is a more all rounder
  29. bro need to confirm by when?

    bro need to confirm by when?
  30. Replies
    183
    Views
    35,847

    Anyone know where to get the tuning hardware for...

    Anyone know where to get the tuning hardware for lancer cs3?
Results 1 to 30 of 500
Page 1 of 17 1 2 3 4