Search:

Type: Posts; User: phanyong

Page 1 of 17 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    916
    Views
    126,393

    Been noticing a lot of DRs on the roads these...

    Been noticing a lot of DRs on the roads these days. After hearing the familiar boom, I'll look around to spot a lancer. Usually I'll still be able to match the sound to the vehicle tens of seconds...
  2. Thread: lancer noob

    by phanyong
    Replies
    1
    Views
    3,678

    Hmm don't understand your deal. What's the Person...

    Hmm don't understand your deal. What's the Person who swapped with you going to do with the faulty side fender?
  3. Replies
    9
    Views
    3,563

    Agree that BBK is overkill, but worth considering...

    Agree that BBK is overkill, but worth considering if the additional top up from slotted rotors and better brake pads is within your budget. Mini 6 for most taiwan makes are going low 1k for first...
  4. Replies
    3
    Views
    897

    Headlight will fail

    Headlight will fail
  5. Replies
    1
    Views
    3,582

    Ok if you're not pulled over by LTA officer. If...

    Ok if you're not pulled over by LTA officer. If you are, exhaust is not legal until you get the cert transferred to your name, complete with inspection cert.
  6. Replies
    9
    Views
    3,563

    I find that changing brake pads alone doesn't...

    I find that changing brake pads alone doesn't achieve significant improvement in braking prowess. If upgrade is what you are looking for, suggest to look into slotted rotors paired with performance...
  7. Replies
    12
    Views
    10,445

    Obviously there'll be risk to any modification,...

    Obviously there'll be risk to any modification, particularly so when it comes to engine. If you want to be absolutely safe, just stick to stock.
  8. Replies
    4
    Views
    4,285

    havent tried remus before but heard not much...

    havent tried remus before but heard not much difference between remus and supersprint.
    I think quite difficult to get hold of remus nowadays so you may be limited to supersprint afterall.
  9. Replies
    4
    Views
    949

    I think it's CY2A or CY4A for Lancer EX

    I think it's CY2A or CY4A for Lancer EX
  10. Replies
    6
    Views
    4,871

    don't think it's possible to buy first hand. need...

    don't think it's possible to buy first hand. need to look out for pple selling second hand ones. Can also try evo forum. Do note that they don't come cheap - pple usually ask for at least 1k.

    Good...
  11. Replies
    6
    Views
    4,871

    original evo 10 bonnet is made of aluminium, not...

    original evo 10 bonnet is made of aluminium, not steel!
  12. Replies
    3
    Views
    4,267

    Fox only for 1.5L

    Fox only for 1.5L
  13. Post photo after installation!

    Post photo after installation!
  14. Wah so powerful brakes, front and back 4 pot!! ...

    Wah so powerful brakes, front and back 4 pot!! Your engine hp must be very the high.
  15. Wait a min, aren't you already on AP racing brake...

    Wait a min, aren't you already on AP racing brake kit?
  16. Thread: Rim sizes

    by phanyong
    Replies
    6
    Views
    1,404

    Can use evo X rims as a guide: 8.5" wide and...

    Can use evo X rims as a guide: 8.5" wide and offset +37.
  17. Thread: HKS to FUJI

    by phanyong
    Replies
    20
    Views
    10,806

    HKS is loud but I don't quite like the hollow...

    HKS is loud but I don't quite like the hollow sound. Prefer the Fuji cos of its low bassy sound. But I must admit Fuji's design is not the most practical.
  18. What can I say, you bought a wrong car. The mods...

    What can I say, you bought a wrong car. The mods you are doing can only fetch you marginal utility cos the baseline was too low to begin with.

    I dare say you'll never be satisfied even if you're...
  19. Replies
    5
    Views
    4,751

    It is perfectly fine that you rims sits inside...

    It is perfectly fine that you rims sits inside your new bodykit. While you can make it flush by either adding spacer or changing to a set of rims with lower offset, it will be for aesthetic and not...
  20. Thread: HKS to FUJI

    by phanyong
    Replies
    20
    Views
    10,806

    What is she unhappy about the HKS? If it's the...

    What is she unhappy about the HKS? If it's the loudness, she might take issue with Fuji too cos it's not that much softer. Plus the low rumbling sound of the Fuji may well make it less acceptable....
  21. If paint is already bad (eg paint chips), don't...

    If paint is already bad (eg paint chips), don't recommend that you do a sticker job. The end result will be bad cos the unevenness of the paint will show.
  22. Replies
    14
    Views
    2,377

    Now I'm wondering if it can take a 9" width rim...

    Now I'm wondering if it can take a 9" width rim without having to open camber.
  23. Replies
    10
    Views
    1,393

    that means the problem is with the bonnet itself....

    that means the problem is with the bonnet itself. The actual mechanism for bonnet release may be stuck. go to a workshop -- they should be able to open the bonnet using means other than relying on...
  24. Replies
    14
    Views
    2,377

    What's the width of your rim?

    What's the width of your rim?
  25. Thread: Fog lamps

    by phanyong
    Replies
    6
    Views
    4,727

    thats your AFS lah dude

    thats your AFS lah dude
  26. Replies
    13
    Views
    3,875

    If can't even take a single hit then I suggest...

    If can't even take a single hit then I suggest don't try both aftermarket kit (tend to go lower than stock) and coilover at the same time. Go for either of the two, or don't lower the coilover that...
  27. Replies
    18
    Views
    3,474

    I find pricing at CH most competitive. The other...

    I find pricing at CH most competitive. The other good point is most likely they can identify which sensor to replace, indent stock to workshop and finally get it replaced for you all within one day.
  28. Replies
    13
    Views
    3,875

    Most likely it will be difficult to clear some...

    Most likely it will be difficult to clear some humps and MSCP with an aftermarket front bumper. but you can always lower first and raise as you need if you find yourself not clearing too many...
  29. Thread: Hazard lt

    by phanyong
    Replies
    2
    Views
    866

    Which bulb? Tail lamp's?

    Which bulb? Tail lamp's?
  30. My comment: You are loaded!

    My comment: You are loaded!
Results 1 to 30 of 500
Page 1 of 17 1 2 3 4